0 Good Luck ASTM C-136 Invalid Your Password 1 / 9 1. 4.When there is Use of Mechanical sieve shaker the total mass of the sample should be………, and the minimum shaking time is………. A) d) 13Kg, 5 minutes B) a) 30Kg, 10 minutes C) c) 20Kg, 10 minutes D) b)10Kg, 20 minutes 2 / 9 2. Report the fineness modulus. When required, to the A) b) 0.02 B) c) 0.05 C) a) 0.01 D) d) None 3 / 9 3. Diameter of the Sieve used for the sieve analysis in this test method is A) c) 11-inch B) d) 12-inch C) b) 10-inch D) a) 8-inch 4 / 9 4. Strike the side of the sieve sharply and with an upward motion against the heel of the other hand at the rate of about A) b) 120 Strokes/min B) d) 25 Strokes/min C) c) 140 Strokes/min D) a) 150 Strokes/min 5 / 9 5. As per ASTM C136 size of test sample after Drying should be minimum A) c) 1000 g B) b) 300g C) d) none D) a) 500g 6 / 9 6. ASTM C136/C136M test method covers the determination of the particle size distribution of A) d) None of these B) a) Coarse Aggregate C) c) Both D) b) Fines Aggregate 7 / 9 7. Balance Used for the Corse aggregate in ASTM C136 is A) d) None of these B) c) 1 g C) b) 0.5 g D) a) 0.1g 8 / 9 8. For sieves with openings smaller than 4.75-mm (No. 4) material should be LESS than A) c) 5 kg/m2 B) b) 12 kg/m2 C) d) 4 kg/m2 D) a)7 kg/m2 9 / 9 9. if the percentage passing the 75-μm (No.200) sieve is less than 10 % it shall be reported to the nearest A) c) 0.1 % B) d)None C) b) 1% D) a) Whole Number Loading Your Result Your score isThe average score is 0% 0% Restart quiz