0 Good Luck ASTM C-136 Invalid Your Password 1 / 9 1. For sieves with openings smaller than 4.75-mm (No. 4) material should be LESS than A) b) 12 kg/m2 B) d) 4 kg/m2 C) a)7 kg/m2 D) c) 5 kg/m2 2 / 9 2. Diameter of the Sieve used for the sieve analysis in this test method is A) a) 8-inch B) c) 11-inch C) d) 12-inch D) b) 10-inch 3 / 9 3. Strike the side of the sieve sharply and with an upward motion against the heel of the other hand at the rate of about A) c) 140 Strokes/min B) a) 150 Strokes/min C) b) 120 Strokes/min D) d) 25 Strokes/min 4 / 9 4. Balance Used for the Corse aggregate in ASTM C136 is A) c) 1 g B) a) 0.1g C) b) 0.5 g D) d) None of these 5 / 9 5. Report the fineness modulus. When required, to the A) a) 0.01 B) d) None C) b) 0.02 D) c) 0.05 6 / 9 6. As per ASTM C136 size of test sample after Drying should be minimum A) a) 500g B) d) none C) c) 1000 g D) b) 300g 7 / 9 7. 4.When there is Use of Mechanical sieve shaker the total mass of the sample should be………, and the minimum shaking time is………. A) d) 13Kg, 5 minutes B) b)10Kg, 20 minutes C) c) 20Kg, 10 minutes D) a) 30Kg, 10 minutes 8 / 9 8. if the percentage passing the 75-μm (No.200) sieve is less than 10 % it shall be reported to the nearest A) b) 1% B) d)None C) c) 0.1 % D) a) Whole Number 9 / 9 9. ASTM C136/C136M test method covers the determination of the particle size distribution of A) b) Fines Aggregate B) a) Coarse Aggregate C) c) Both D) d) None of these Loading Your Result Your score isThe average score is 0% 0% Restart quiz